Entry # 44

ETNA Supply

Designer: Kyle Potgeter

Customer: Byron Center, Mich.

Installation Location: Residential Design Build

Brief overview of the project

Brief overview of the project, what Caleffi products were used?

Used a bunch of the Caleffi zone valves ranging in sizes from 3/4" to 1-1/4".

Design goal

What was the design goal? Is it a heating, cooling, or plumbing system? Or combination of?

This is a design build for a residential in-floor radiant heating system. There is also an indirect-fired water heater being run off the boiler.

Installation description

New Installation or retrofit? Was there any special challenges in the design or installation

This is a new installation. We had a little bit of a tough time coming up with how we were going to get to all of our zones since we have a lot of remote manifolds located throughout the house.

System performance

How is the system performing now?

The system runs great. It's been another hard winter in Michigan and the homeowner loves how the system is performing. He says the heating bills have not been nearly as bad as what he was anticipating.